The primary objective of this research was to validate the finite element (FE) stress levels obtained during previous research through physical testing of a selected knuckle design. The validated FE model was used to investigate potential improvements in knuckle fatigue life, such as higher tensile strength material and design changes to critically-stressed knuckle locations. Researchers found that the fatigue life of a coupler knuckle can be improved nearly 400 percent by increasing the tensile strength for M-201 Grade E steel from the present Association of American Railroads minimum of 120 ksi to 125 ksi. Increasing the thickness at two key locations in the studied knuckle increased the fatigue life by 83 percent even for the minimum tensile strength of 120 ksi for Grade E steel. A design of experiments approach for optimizing the knuckle based on the tensile strength, thickness of the inner face, and spacing of the cores at the flag hole is recommended. This method will find the optimum design parameter changes to achieve the best knuckle fatigue life possible under the geometry and weight constraints.
This paper describes a systematic methodology to estimate allowable limits for rail head wear in terms of vertical head-height loss, gage-face side we...
The effects of manufacturing method, chemical composition, heat treatment, temperature, and loading rate on the plane strain fracture toughness KIC of...
Links with this icon indicate that you are leaving a Bureau of Transportation
Statistics (BTS)/National Transportation Library (NTL)
Web-based service.
Thank you for visiting.
You are about to access a non-government link outside of
the U.S. Department of Transportation's National
Transportation Library.
Please note: While links to Web sites outside of DOT are
offered for your convenience, when you exit DOT Web sites,
Federal privacy policy and Section 508 of the Rehabilitation
Act (accessibility requirements) no longer apply. In
addition, DOT does not attest to the accuracy, relevance,
timeliness or completeness of information provided by linked
sites. Linking to a Web site does not constitute an
endorsement by DOT of the sponsors of the site or the
products presented on the site. For more information, please
view DOT's Web site linking policy.
To get back to the page you were previously viewing, click
your Cancel button.
United States Department of Transportation
[PDF-3.06 MB]
